[No...] Posted November 22 Share Posted November 22 (edited) Does anyone else experience frequent connection problems to either the sensor (here: ATOS Capsule) or the automation hardware (here: GOM ROT 640) in Inspect 2025? Almost every time when I start the software after powering up sensor and table, the initial connection to one or both of them fails. In some cases I can establish a connection on the second try, but often no connection is possible at all and I have to power down the devices again and restart the software. This does NOT happen with software 2023. Sometimes the sensor needs some time until its ready after power-up, but after that the connection always works. Connecting to the rotary table has never failed. Edited November 22 Link to comment Share on other sites More sharing options...
[Na...] Posted November 22 Share Posted November 22 Hello, a wild guess would be some kind of interference by a security program/virus scanner, where Inspect 2025 is not permitted yet. If not, please contact the support with a fresh gomsic, ideally. Nanno Link to comment Share on other sites More sharing options...
[No...] Posted November 25 Author Share Posted November 25 (edited) I'll be watching the issue for some time and try some things, but then yes, I'll contact support. I just wanted to put out a feeler here if this might be an already known problem and possibly software/driver related. Edited November 25 Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in