Acceptance Test, is the GAT-10360-8 script pre-installed?

[[Mi...]]

We want to run Acceptance Tests using the GOM Probing/Spacing Artifact 400 , carbon plates with steel spheres to test diameter and distance made by DYNAMIC(?)

The  GOM Inspect help shows a script being used to run the tests with drop down menus for which lens set is being evaluated.

I did a search on the local machine for the python script with no luck.

 

 

[[Ax...]]

First, you need to create a template. To do this, you need the script, which you can install as an add-on.
Only then can you perform the verification with the template.

[[Qu...]]

Hi Axel, 

Do you have a step-by-step for running this in the latest software? I have successfully set up both templates and master templates, and run the 3 tests using the 'expert' drop down to run the calibration and 3 positions in one, but have not had success in evaluating once data is collected. Is there a script that polygonizes and runs the evaluation? I can only see an 'export evaluation script. All of the manuals refer to analysis on software pre-'part-project'. Perhaps Mike will get further than I did but a step-by-step would be useful. 

[[Ax...]]

Only in German. Maybe, you can find it @downloads

[[Ky...]]

Hi Quintus, 

Axel is Correct the script can be located in the software store. you can find this on page 12 in the software store. 

as for a step by step by step guide. one is normally provided with the Training class that Zeiss hosts for VDI's 

if you are interested  in that class i would reach out to your sales rep or to your support provider.