GD&T engine MMC

[[Pa...]]

I've just started working with Calypso 2024.  Using the GD&T position with MMC invoked, my report now shows the size of every hole used to calculate the bonus tolerance.  I'd like to remove this from the report, as the same hole sizes show up once in the PLTZF, once in the FLTZF, and once where I just called for the diameter.  My part has 100 holes so eliminating these redundancies will remove 200 lines from the report.  

I'm just poking around now to see if I can find a setting somewhere but any help would be appreciated.

[[Ky...]]

I don't think the separate characteristics are necessary in the new GD&T engine. After you make sure that the size tolerance is set correctly in the characteristic (the diameter symbol next to the MMC symbol in the characteristic), you can delete or hide any additional diameter characteristics you or the system made (see https://portal.zeiss.com/knowledge-base?id=1128721 for instructions on hiding the characteristics, assuming you are in the US).