Lack of power supply and problem with starting the drives

[[Ma...]]

Hi,

Recently, we have had multiple issues with the electrical power supply.

After these problems, we are unable to start the drives on CMM

Patient: CMM Zeiss Duramax

On the control panel, the following message appears:

His anyone has this problem beofore?

Can I tak any actions on my own to try to start the drives?

O would like to add that I have already tried moving head manually along each axis, so this is not a issue related to the machine hitting a limit switch at the moment of power outage 

[[Ma...]]

If it's same pictograms as for our Accura, then machine needs to get home position ( that's REF ) / key is indicating turned key for slower speeds.
Exclamation mark would be indication of homing or not turned on drives.

Have you tried turning machine completely off for a minute? Also i am holding drive button for a few secs ( on remote you must, on machine you can )

[[Ma...]]

Please sign in to view this quote.

 

I've been working on a CMM for a quite a few years and I never noticed that this pictogram refers  to this operation 😄 Thanks Martin 🙂

Yes, I tried restarting CMM several times and also held the drives button, but it didn't help.

We'll probably have to call service

[[No...]]

Sounds stupid, but have you checked the emergency stop button? 

Don't laugh! 

Many years ago I had similar issues and was close to calling the service when finally I noticed the emergency stop was enabled. I had pressed it myself accidentally with my belly when leaning over the machine. 🤭

Ok, laugh. 🙄