[Lo...] Posted 5 hours ago Share Posted 5 hours ago Hello everyone, I am having an issue with the profile traces on splines I am inspecting. They look horrible but the lead traces seem to look fine. Believe I ran into this before but can't remember how I remedied this. Included the gearing data and I am also using a 1mm probe. I am evaluating all 11 teeth not just 4. Not sure if that is something that needs to change or not. I am sure I left some details out that could help. Thanks for any assistance. Lou Link to comment Share on other sites More sharing options...
[Ri...] Posted 4 hours ago Share Posted 4 hours ago 1mm styli is too large for an internal spline of this size. You should either use a 0.3mm or 0.5mm given the available tooth length is only 0.05" (1.3mm). In addition, speed is also a factor - short splines require you to go much slower (especially on the involute/profile). 1 Link to comment Share on other sites More sharing options...
[Lo...] Posted 1 hour ago Author Share Posted 1 hour ago Please sign in to view this quote. Thanks Richard. Have a .5mm probe but ended up cutting the part down to get the probe to reach. And slowed the CMM down. Lines are a lot straighter than before, notice there is quite a bit of pitting or chipping on the splines as well. I'm sure thats not helping much. Thanks again. Lou 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in