CMM program wants a probe that isn't in the program.

[[Ri...]]

I have this one stubborn program, every time I open it, I am warned that a probe is not available.

Combo86R-2

It is not used in the program; it has never been used in the program.

Any ideas on how I may be able to find a rogue entry in some file?

[[Du...]]

Have you checked the stylus system dropdown in the measurement plan editor features?

[[Th...]]

I know that probe names show up in the inspection file if I search for them.

[[Ke...]]

Have you checked which stylus is used under "Meaasurement Plan Editor Features"?

Or are there any known position points that might have been misassigned?

[[Ri...]]

I have checked the obvious, Measurement Plan Editor, no entries shown.

I did find entries in "inspec" and "inspection" files.

Editing those entries caused some weird problems (Altered the entries to be Combo86R). 😂

inspec file:

Please sign in to view this quote.

inspection file:

Please sign in to view this quote.

I could not find an "#identifier" within plus or minus 30 lines of the "Combo86R-2" line.

Edited Thursday at 05:16 PM

[[Do...]]

CMM positions and start/end park positions are sneaky places where probes can be assigned, but are not visible via the Plan Editor.

[[Ri...]]

Screen shot of used probes in the program, not showing this Combo86R-2 which is an actual probe.

[[Ch...]]

Please sign in to view this quote.

could also be hiding in an 'intermediate point' in a strategy , perhaps you wont see that in the plan editor. 

 

 I've had this happen occasionally while opening and reviewing strategies etc.

[[Ke...]]

You could try assigning a different stylus system and then changing it back, to try and overwrite any hidden problems 🤷‍♂️

[[Ch...]]

That was my next suggestion as well, this might cover any intermediate points that are mis-assigned, if you just re-assign all probes in the test editor...

[[Br...]]

Another place to check is your CMM END PARK POSTION 

there might be a Stylus/system in there that no longer exists.

[[Ri...]]

I am not or have not used park positions in this program.

[[ni...]]

with a copy of your program, defined new elements for the aligment and erase all the other element and try to launch the program, if the problem is still there it's not cause of an element, if the problem disappear, do the same thing again and erease just half of the other element (and a quarter and a 1/8....) to find the problem element.

[[Je...]]

Sounds like the stowaway onboard your program is doing a good job at hiding.

You've checked the obvious places.

Any stones left unturned as pcm in comments or stylus qualifications or shady, dimly lit taverns?