Ziess Inspect Crashes when I go to the set up tab to Configure Lens

[[Ch...]]

I have been able to get the sensor I am using recognized by the software and the software will connect to it. I can not initialize the sensor however because when I try to it wants me to update the configuration in the setup. This makes sense since the lens setup and calibration need to be done. The problem is when I try to go the setup tab it crashes every time. I am unsure of what the cause is because I have confirmed that I have the up to date software and drivers installed. I also have a graphics card that the system has said fit the requirements. The sensor status is checking green and I have run through the web interface as well and the sensor again shows no problem. This all leads me to believe that this is a software issue rather then a hardware issue but I am unsure how to fix it.

 

Thank you,

Sam