Dynamic Profile

[[To...]]

This is the first time I've seen a dynamic profile this and need a little help with setting this up in Calypso 2023.  This a marked up drawing so excuse the lack of exactness on the profile callout. I think I'm all set with the upper tier but not sure about the lower tier, especially with the unequal distribution.  Any feedback would be greatly appreciated.

Edited Tuesday at 01:15 PM

[[Jo...]]

Hello,

maybe you find what you need here:

 

[[To...]]

Please sign in to view this username.

 Thank you for the link. Unfortunately, it doesn't quite address my situation.  I actually have a copy of ASME Y14.5-2018 and it doesn't cover my specific situation either.  I think the engineer that marked up the drawing might be taking some liberties with the interpretation of the standard.

Edited Tuesday at 03:16 PM

[[Jo...]]

I even have the supplemental ASME publication (Which is AWESOME and I cannot recommend enough!  "Applications, Analysis, Gauging & Measurement" by James D Meadows) and i still barely understand it. 

When our engineers specified it, I pushed back and it turns out they didn't understand it either and actually wanted form.  

[[Ed...]]

I am also trying to understand dynamic profile, but here are my thoughts:

Based on the description of dynamic profile tolerance zone on page 244, I don't think it makes sense to have an unequal disposed tolerance zone.

To get the result, i would use Profile with Bilateral-two results. Then report the difference between the min and max.