How to set a "MAX" or "MIN" tolerance?

[[Is...]]

There are times when we get a drawing with a dimension callout of, for example, .17 MAX or .17 MIN.

I can figure out several ways of doing this with bilateral tolerances, but I wanted to know if there's a more intuitive or straight-forward way of setting this kind of tolerance in Zeiss Inspect.

Thanks!

[[Ma...]]

I usually uncheck other tolerance so you have only one side.

We are reporting mismatch of upper and lower half of a part where it's always positive and ideally it's ZERO - so it looks ugly when it's warning while closer to ZERO