Zeiss inspect 2025- Check position Spherical evaluation

[[Ak...]]

Hello all, I have a problem with evaluating this position. The problem is that when I position MP02 relative to base 'V', I get the resulting value as shown in the picture. So how do I make the measurement result match what the drawing asks for?

Edited September 21

[[Ma...]]

I think Spherical tolerance can not be applied here unless you use some intersection points from cylinder and plane.

Otherwise it should be just planar.

Also i am curious why are you using only circles. Any RPS on drawing?

[[Ak...]]

Hi, MP02 and base "V" are the intersection points of the cylinder and the plane. I added the circles there to make it clear that both the point and the circle have the same value. Yes, it's on drawing RPS-321. I have this problem elsewhere too, only when I want to evaluate it spherically.