Modifying piweb report in Calypso

[[Ja...]]

I have updated the standard protocol report, but i cant figure out how to add full page sheets for each CAD Presentation and Line Profile plots.

As we are getting more and more Limited Dimension Drawings, and we have to show we have measured all features, I was using curves for profile requirements and then plotting them on the report.  Later, after complaints by Source Inspection that the plots were not enough, so I added CAD Presentations, but they are so small its hard to see. I wanted to have it do a full page for each plot and for each CAD Presentation.  I have attached the report as well.

below are three pictures:

1 - current report view

2 - PiWeb Designer through Calypso

3- Plot of CAD Presentation through Characteristic tab

     1 - 

 

2 -   

3 - 

 

Excel StandardProtocol.zip Excel StandardProtocol.ptx

Edited Thursday at 12:10 PM
added pictures for clarity

[[Ed...]]

Unhide 3 - Plot sheet from your second image.  You may need to hide 5 - Picture; on 2024 on our CMM cad evaluation shows up with 3 - Plot.

[[Ja...]]

That works, but it still prints a blank page if there are not plots.

[[Th...]]

You can solve that by going to View > Filter pages > By page status and setting the radio button for pages with measured data and saving the report template.