Jump to content

Recommended Posts

Hello, we have a new part type to inspect. I have a Gun Barrel with two ID's to measure with an inner and outer ID.

Has anyone tried this on an CMM? I was going to scan the ID and possibly try to extract a max and min circle if possible.

Just getting started with a fixture and probe set-up, any tips based on previous similar measurements is appreciated.

Thanks 

 

  • Like! 1
Link to comment
https://qualityforum.zeiss.com/topic/27694-inspecting-gun-barrel-ids/
Share on other sites

×
×
  • Create New...