setCF for dynamic selection of Characteristics

[[Ca...]]

Hello CMM Team,

I want to select dynamically a set of dimensions, so we can create ad-hot miniplans

This is an example. Normally all the checkBoxes are selected, but if you select only a few, a LIST with these dimensions or characteristic is created and ready for a PreSettings.

The Issue is when I try to measure some Characteristics that need features not defined in the alignment. Here an example of the questions by the Calypso system:

Some ideas to avoid create a list ddME before calling setCF.

[[Je...]]

you can use addME("Feature1", "Feature2",etc) to predefine all needed Features.

If you use this, you will have to run from feature-list.

Edited 5 hours ago