Avoid repetition of an element

[[Da...]]

Good morning, colleagues,

Where can I enable or disable the option to repeat the measurement of an item—for instance, in cases where it was processed too quickly or without the necessary force?

Edited 11 hours ago

[[Ma...]]

I would guess in features editor, but i never saw that option. I was only using a loop to remeasure feature on condition.

[[No...]]

Do you mean the rescan function of an XXT? It's in the compatibility options, but I don't remember what it's called. You'll know it when you see it. I think you can only enable or disable for the whole measurement plan. In older plans its off by default (backwards compatibility), in new ones it's on.

Edited 10 hours ago

[[Sv...]]

If an XXT probe is being used, I sometimes adjust the speed. For instance, if I’m scanning a bore at 10 mm/s and the operation is repeated continuously, I’ll reduce the speed to 8 mm/s—that usually helps. I also once came across a solution on the forum where a circle is probed using four individual points; then, within the scanning measurement element, the actual X and Y positions are retrieved via a formula.

[[Da...]]

Please sign in to view this quote.

Así es, muchas gracias!

[[Lu...]]

if you have too mutch air scanning warnings you should ajust the stylus on calibration and in program the force from standard to rubust

[[Ri...]]

Please sign in to view this quote.

Correct, I had asked a similar question in regard to Scanning Optimization with the XXT sensor.

It can only be disabled program wide and is not recommended to disable.

 

[[Ma...]]

certain features like circles allow you to put in a reference feature which will allow you to move faster without the air scanning. for those I do a 3 or four point circle as my reference then in a separate feature use the scanning option to go faster. this is helpful if you have a problem child, but doing it for every circle is not always faster.