How define an plate stylus in Stylus-Kit Software

[[Ka...]]

Hi Expert,

We need to use plate stylus which must be simulated by Planner ( No joke, it’s a grim reality... )
CALYPSO 7.4.24

Using the Zeiss Stylus-kit 1.7.8817 I can define a plate stylus using generic geometry. At the End I´m not able to define the plate as a sensor. Try to load the ssc file in planner end´s with and error message.
How do you define your own plate stylus to be able to simulate this in Planner??

[[Ri...]]

Your info is blocked in your image, Im guessing its similar to this setup. I use these all the time and show a full Disk in Planner.

See image.

Attached is an SSC file you can look at. (In 7z zipped format.

Combo76R.7z

Edited Friday at 12:18 PM

[[Ka...]]

Hi Richard,

Thank you for the example and the hint to use a generic stylus.

All I can define is a small tip and align DS / DG / L in this way that the tip is plan to the disk. In this case I can use the stylus only in -Z direction. But I need to use the disk stylus as a real physical stylus, means the outer diameter of Ø14, the plane in -Z as well as +Z.

How to define such a stylus?
Attached my example ....

Regards
Karsten
 

Q42421.zip