[To...] Posted yesterday at 12:57 PM Share Posted yesterday at 12:57 PM Hi all, I’ve set up pallets before and have never run into this issue. I’m using a large fixture with 50 ×\times× 48 slots, for a total of 2,400 parts. When I set up the pallet to measure 96 parts (32 ×\times× 3), the CMM measures them in order, from part 1 through part 96. However, when I increase the number of parts on the same fixture—for example, to 32 ×\times× 6 for 192 parts—the CMM doesn’t follow the expected order. It might measure parts 1, 2, 3, and 4, then jump to 7, 6, and 5, and continue with 8, 9, and so on. In other cases, it measures parts 1 through 32, then goes to part 64 and works backward through 63, 62, and so on. I use the Select All feature rather than selecting the parts manually. My measurement plan is set to measure parts 1 through 192, with a step of 1. It’s important that the parts are measured in order because they’re cavity-driven, and I need to compare parts across different lots. Has anyone experienced a similar issue? Is there a setting I might be missing? Thank you Link to comment https://qualityforum.zeiss.com/topic/27886-pallet-in-autorun-skipping-parts/ Share on other sites More sharing options...
[No...] Posted yesterday at 01:29 PM Share Posted yesterday at 01:29 PM I think I remember that a long, long time (years) ago somebody complained about Autorun not keeping the order of pallet positions or even skipping measurements completely when the number of parts exceeded a certain threshold. But I can't find that post again now. It might have had to do with a specific Calypso release only. Link to comment https://qualityforum.zeiss.com/topic/27886-pallet-in-autorun-skipping-parts/#findComment-158334 Share on other sites More sharing options...
[To...] Posted yesterday at 01:35 PM Author Share Posted yesterday at 01:35 PM I was researching the forum before I posted, and I couldn't find anything similar. I'm still searching. Thank you. Link to comment https://qualityforum.zeiss.com/topic/27886-pallet-in-autorun-skipping-parts/#findComment-158336 Share on other sites More sharing options...
[No...] Posted 7 hours ago Share Posted 7 hours ago Better don't rely on my long-term memory.....🤯 Link to comment https://qualityforum.zeiss.com/topic/27886-pallet-in-autorun-skipping-parts/#findComment-158370 Share on other sites More sharing options...
[Ma...] Posted 4 hours ago Share Posted 4 hours ago Well if you have always full fixture, then you can define exact order ( you can define start/end and step ) - that is fixed and can not be changed by clicking on part square. That would be better than manually selecting in correct order. Link to comment https://qualityforum.zeiss.com/topic/27886-pallet-in-autorun-skipping-parts/#findComment-158380 Share on other sites More sharing options...
[Ri...] Posted 3 hours ago Share Posted 3 hours ago Please sign in to view this quote. Make two pallets of both 32x3. That should get you through the run. 1 Link to comment https://qualityforum.zeiss.com/topic/27886-pallet-in-autorun-skipping-parts/#findComment-158392 Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in