[Ti...] Posted August 14 Share Posted August 14 Good morning everyone, I have a new star probe that the shaft length is only 5mm long so of course I can not calibrate it going to 180 degrees of my sphere, I lowered the sphere coverage but the probe it still trying to calibrate at 180. What am I missing? Link to comment Share on other sites More sharing options...
[Ma...] Posted August 14 Share Posted August 14 You can not use dynamic tensor - this will always do 180° coverage Link to comment Share on other sites More sharing options...
[Ti...] Posted August 14 Author Share Posted August 14 Please sign in to view this quote. So where can I change this? Link to comment Share on other sites More sharing options...
[Ma...] Posted August 14 Share Posted August 14 When you are doing manual calibration, then in top middle there is combobox with Dyn. tensor. I think regular "Tensor" will do it. Otherwise there is 6 points. Link to comment Share on other sites More sharing options...
[Mi...] Posted August 14 Share Posted August 14 If this is an XXT machine, you can't, you need a smaller sphere. Link to comment Share on other sites More sharing options...
[To...] Posted August 14 Share Posted August 14 Sounds like you have an XXT sensor, which ALWAYS performs the scanning portion of the Passive qualification at 180°. The angle property only comes in to effect during the 6 points after the scanning portion. However, you've built the bending parameters on the full 180°. As Mike mentioned, a smaller diameter (8mm) reference sphere will be required. Link to comment Share on other sites More sharing options...
[Ca...] Posted August 20 Share Posted August 20 In any case, you will need a small calibration ball with a diameter of 8mm. I had the same problem and was only able to solve it this way Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in