[To...] Posted September 14, 2023 Share Posted September 14, 2023 Any suggestions for setting up a surface profile of Freeform Surface2 to FFS1? Would I make an alignment from within FFS1 and use it for the datum reference in the profile? If so, what settings are required for the alignment? If you need more info, let me know so I can get it for you. Link to comment Share on other sites More sharing options...
[Ma...] Posted September 14, 2023 Share Posted September 14, 2023 Any hints of your desire? I am little tired so i can not imagine too much 🙂 Link to comment Share on other sites More sharing options...
[Ri...] Posted September 14, 2023 Share Posted September 14, 2023 Can you show an example of the callout? It mainly depends on what FFS1 would be constraining - what degrees of freedom are allowed to translate/rotate. Setting up the alignment inside the FFS is essentially like when you setup a Geometry Best Fit. Link to comment Share on other sites More sharing options...
[To...] Posted September 14, 2023 Author Share Posted September 14, 2023 Please sign in to view this quote. I don't have a drawing yet so I don't have any specifics just yet. FFS1 is a concave shaped mirrored surface tied to a plane and 2 holes on the base of the part. FFS2 is a convex shaped mirrored surface tied to FFS1. I've attached a screen capture of the concept but not actual part. Like GBF but with a few extra options???Screenshot 2023-09-14 100320.jpgScreenshot 2023-09-14 095408.jpg Link to comment Share on other sites More sharing options...
[Ma...] Posted September 14, 2023 Share Posted September 14, 2023 If it would be this case , i would enable only movement without rotation and chebysev. But real results will show which method can be used. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in