[TJ...] Posted January 23, 2023 Share Posted January 23, 2023 Long-time reader, first-time poster! Straight up, newbie! I am trying to measure a part with difficulty I can't figure out in Calypso. The drawing calls for a circle in contact with the two 45-degree angles. I need to measure from the symmetry of the 2mm slot to the center of this circle. I am trying to figure out how to make this circle from two 45-degree plans. Any help would be GREAT! See attached drawing 3511- Drawing.pdf Link to comment Share on other sites More sharing options...
[Ün...] Posted January 23, 2023 Share Posted January 23, 2023 Hello, As far as I understand there is no Curve. give this a try Link to comment Share on other sites More sharing options...
[TJ...] Posted January 23, 2023 Author Share Posted January 23, 2023 Thanks, I will give this a try! Link to comment Share on other sites More sharing options...
[Fl...] Posted January 23, 2023 Share Posted January 23, 2023 Hi, try to make Tangents, with 2 lines on the 45 degree plains, you can set up the theoretical diameter and then get a circle as feature. Best regards, Florian Link to comment Share on other sites More sharing options...
[TJ...] Posted January 23, 2023 Author Share Posted January 23, 2023 I tried both ways, and it worked great for me! Thanks for the help! Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in